CPS strong reaction sticky adhesive waterproofing membrane cross laminated membrane technology I. Introduction 1. Introduction CPS strong reaction sticky adhesive film laminated cross capillary crystalline waterproofing membrane made of imported materials and a variety of parent company Wacker series high Waterproof aids for accessories, a scientifically formulated efficient, environmentally friendly waterproof coating. Material in the active material can be sufficiently dissolved in water, and water as a carrier molecule to penetrate the concrete. In concrete generate a chemical reaction with other active substances sturdy water-insoluble crystals, thus clogging the pores of the concrete and a small gap, increase the density of concrete to waterproof effect is a kind of self-healing capabilities of high-tech building waterproof materials . Self-healing capabilities of high-tech building waterproof material. Product Standard: "cementitious capillary crystalline waterproofing materials" GB 18445-2001, and at the same time achieve the requirements of GB 50108-2008 "underground waterproof engineering technical specifications." Two, CPS strong reaction cross laminated film adhesive stick waterproofing membrane Features 1) non-toxic, environmentally friendly, with permeability. 2) water penetration crystal, with a secondary impermeability. 3) coating sturdy construction can be carried out directly on the follow-up thereon, do not need another layer of protection. Apply a range of 4.3) for a waterproofing of underground works. Waterproof 2) for the construction of underground water, parking, railways, tunnels, pools, indoor and outdoor swimming pools and other parts of the concrete building, moisture treatment three points 1. for residential interior design waterproofing, CPS should use a strong reaction sticky layer One number and password waterproof waterproof password No. II. 1.1 Residential bathroom, kitchen, bathroom with water points enclosed balcony, pool, etc. should be waterproof design, and appropriate technical measures should be adopted: 1) Bathroom in a waterproof design, building, floor waterproof layer should be set, walls, ceiling vapor barrier should be set, and should be set up to drain drainage facilities, etc., when there is a non-enclosed bathing facilities, wall waterproof layer should be set; the door should have water spill prevention measures. 2) kitchen in a waterproof design, the floor, the ground water level should be set, wall vapor barrier should be set; the kitchen is arranged at the lower point of the room without water, ceiling vapor barrier should be set. 3) has a supply point for the enclosed balcony, walls should be waterproof, moisture-proof ceiling should, floor, pool design, construction should be waterproof integrity; situ concrete pools should be waterproof concrete, and should be used "Goju "waterproof layer. 4) Note: (1) complete construction waterproofing layer must have the conservation of 2d ~ 4d, to avoid cross-operating period. (2) in a waterproof layer before the primary surface have adequate strength. (3) Construction of the temperature between 5 ℃ ~ 35 ℃, low temperature, high temperature are not construction. (4) For water test must be carried out in 2d ~ 4d after the end of the waterproof layer construction, 24h after the water should be excluded. (5) products containing polymer composition, do not let it touch the eyes and respiratory tract, as it gets, immediately rinse with water and seek medical advice. Four, CPS strong reaction cross laminated film construction elements sticky adhesive waterproof membrane: 1) the base surface is smooth and no structural defects, with high impact strength, no laitance, dust or contaminants. Before 2) construction should be based on design requirements, to determine the number of times the amount of material and construction unit area. 3) to be sealed on the detailed structure or enhanced treatment, and then a large area waterproofing. 4) coating to avoid direct contact with the skin, need to wear rubber gloves when construction accidentally splashed into the eyes must first rinse, and promptly to the hospital for treatment. 5) Do not freeze or frost on the surface of the construction, when the ambient temperature is below 5 ℃, not construction. 6) No construction in the rain, and to ensure that the front surface of the waterproof layer is not cured rain. Fifth, product images and vision